Ecological studies on high-rate biological filters with special reference to microbial biosynthesis and nitrification

Pilot scale studies of high rate filtration were initiated to assess its potential as either a primary 'roughing' filter to alleviate the seasonal overloading of low rate filters on Hereford sewage treatment works - caused by wastes from cider production - or as a two stage high rate process to provide complete sewage treatment. Four mineral and four plastic primary filter media and two plastic secondary filter media were studied. The hydraulic loading applied to the primary plastic media (11.2 m3 /m3 .d) was twice that applied to the mineral media. The plastic media removed an average around 66 percent and the mineral media around 73 percent of the BOD applied when the 90 percentile BOD concentration was 563 mg/1. At a hydraulic loading of 4 m3 /m3 .d the secondary filters removed most of the POD from partially settled primary filter effluents, with one secondary effluent satisfying a 25 mg/1 BOD and 30 mg/1 SS standard. No significant degree of nitrification was achieved. Fungi dominated the biological film of the primary filters, with invertebrate grazers having little influence on film levels. Ponding did not arise, and modular media supported lower film levels than random-fill types. Secondary filter film levels were low, being dominated by bacteria. The biological loading applied to the filters was related to sludge dewaterability, with the most readily conditionable sludges produced by filters supporting heavy film. Sludges produced by random-fill media could be dewatered as readily as those produced by low rate filters treating the same sewage. Laboratory scale studies showed a relationship between log effluent BOD and nitrification achieved by biological filters. This relationship and the relationship between BOD load applied and removed observed in all filter media could he used to optimise operating conditions required in biological filters to achieve given effluent BOD and ammoniacal nitrogen standards.

The influence of environment on foliose lichen growth and its biological significance

Radial growth and growth in mass of lichens is influenced by climatic and microclimatic factors and also by substratum factors such as rock and bark texture, chemistry, and nutrient enrichment. Seasonal fluctuations in growth, as measured by radial growth rate (RaGR) per month, often correlate best with average or total rainfall, the number of rain days, or rainfall in a specific season. Temperature is also considered to be an important climatic factor in some studies. Interactions between microclimatic factors and especially light intensity, temperature, and moisture are the most important in determining local annual growth rates. The physical and chemical nature of the substratum has a profound influence on the growth of foliose lichens. Hence, the effects of texture, porosity, rate of drying, and the physical changes of the substratum on growth are likely to influence lichen distributions. Bird droppings may influence growth and survival by smothering the thalli, altering the pH, or adding inhibitory and stimulatory compounds. Nitrogen and phosphate availability may also influence growth. Chemical factors may also have an important influence on lichens of maritime rocks, the effect of salinity and calcium ions being of particular importance. Zinc, copper, and mercury may also be important in lichen growth as they have been shown to affect the chlorophyll content of lichen algae. Effects of environmental factors on growth influence the competitive ability of lichens thus influencing their ecology and distribution.